Connecting Wires - LEGRAND Wattstopper UT-305-1 Mode D'emploi

WARNING: TURN THE POWER OFF AT THE
CIRCUIT BREAKER BEFORE WIRING.
Each Wattstopper BZ series power pack can supply power for 5 UT-305 sensors.
When using more sensors than this, multiple power packs are required.
Refer to the wiring diagram for the following procedures:
Connect the low voltage:
• RED wire (+24VDC) from power pack to the +24V terminal on the sensor.
• BLACK wire (Return) from power pack to Common terminal on the sensor.
• BLUE wire from power pack to Control Out terminal on sensor.
To add a manual switch such as the LVS-1 Momentary Toggle Switch, or RS2-3
Low Voltage Momentary Switch to the above applications–connect:
• Wire from one side of switch to +24V terminal on sensor.
• Wire from other side of switch to Man Switch terminal on sensor.
• Care should be taken to separate high voltage power from low voltage (Class 2) control wiring.
• All connections to sensor are low voltage, Class 2.
Standard wiring with local off switch
Line
Neutral
Power Pack
Low Voltage
Class 2
Black
Common
Blue
Red
Control Out
+24V
Ceiling
Depluggable
Terminal
Spring Clips (2)
Rear Housing
Front Cover
UT-305
WIRING DIRECTIONS
Feed Through
Load #1
Load #2
(Optional)
Line
Voltage
#1
Line Voltage
Switches

CONNECTING WIRES

Manual-On wiring with low voltage momentary switch
Power Pack
Low Voltage
Ceiling
Depluggable
Terminal
Spring Clips (2)
#2
Rear Housing
Front Cover
2
03624r2
Line
Neutral
Class 2
Red Blue
+24V
Control Out
Black
Common
Man.Switch
UT-305
UT-305
v3
Ultrasonic
Occupancy Sensor
LISTED
40kHz Ultrasonic
88T9
Appliance +24VDC/VAC
Control
Connect to Watt Stopper
Class 2 Power Packs
For Indoor Use Only
Control Out.
U.S.Patents:
5,640,113
Patent Pending
Man. Switch
+24V
Common
Wiring
terminals
Feed Through
Load
Line Voltage
+24V
Man.Switch
Jumper
Back
of
LVS-1
LVS-1
For low voltage
momentary switch, set
DIP switch #6 ON