AEG IKE95771FB Notice D'utilisation page 99

Problem
The control bar blinks twice and
turns off.
and a number come on.
10.2 If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Make sure, you operated the hob
correctly. If not the servicing by a service
11. TECHNICAL DATA
11.1 Rating plate
Model IKE95771FB
Typ 62 E5A 07 AA
Induction 7.2 kW
Ser.Nr. .................
AEG
11.2 Cooking zones specification
Cooking zone Nominal power
(maximum heat
setting) [W]
Middle rear 1800 / 3500
Right front 2300
Possible cause
The diameter of the bottom of the
cookware is too small for the zone.
FlexiBridge (Flexible Bridge) oper‐
ates. One or more sections of the
function mode which operates are
not covered by the cookware.
PowerSlide operates. Two pots are
placed on the flexible induction
cooking area or the cookware covers
more than one cooking area activa‐
ted by the function.
There is an error in the hob.
technician or dealer will not be free of charge,
also during the warranty period. The
information about guarantee period and
Authorised Service Centres are in the
guarantee booklet.
PNC 949 597 900 00
220 - 240 V / 400 V 2N 50 Hz
Made in: Germany
7.2 kW
PowerBoost [W]
2800 / 3700
3200
Remedy
Use cookware with correct dimen‐
sions. Refer to "Technical data".
Place the cookware on the correct
number of sections of the function
mode which operates or change the
function mode. Refer to "Flexible in‐
duction cooking area".
Use only one pot. Refer to "Flexible in‐
duction cooking area".
Deactivate the hob and activate it
again after 30 seconds. If
on again, disconnect the hob from the
electrical supply. After 30 seconds,
connect the hob again. If the problem
continues, speak to an Authorised
Service Centre.
PowerBoost Cookware diame‐
maximum dura‐ ter [mm]
tion [min]
10 / 10 145 - 245 / 245 - 280
10 125 - 210
ENGLISH
comes
99