Toro Recyler Mode D'emploi page 7

Figure 4
1. Pin
Note: The pins do not show through the holes in the
handle ends when the handle is in the folded position.
3. Unfold the handle to the operating position by rotating
it rearward (Figure 5).
Figure 5
1. Folded position
4. Insert the carriage bolt (with the bolt head toward
the inside) through the upper or lower square hole in
handle bracket and the upper hole in the handle end
(Figure 6).
g032866
2. Handle end
g032868
2. Operating position
1. Handle knob
5. Loosely install the handle knobs onto the carriage bolts.
6. Refer to steps 3 through 5 of
Height (page 10).
2
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle and pull the
recoil-starter rope through the rope guide on the handle
(Figure 7).
1. Recoil-starter rope
5
Figure 6
2. Carriage bolt
Adjusting the Handle
Figure 7
2. Rope guide
g032869
g003251