Publicité
Les langues disponibles
Les langues disponibles
•
If there are more than 13 cm (5 inches) of leaves on the
lawn, set the front cutting height 1 or 2 notches higher
than the rear cutting height.
•
Slow down your mowing speed if the machine does not
cut the leaves finely enough.
After Operation
After Operating Safety
General Safety
•
Clean grass and debris from the machine to help prevent
fires. Clean up oil or fuel spills.
•
Allow the engine to cool before storing the machine in
any enclosure.
•
Never store the machine or fuel container where there is
an open flame, spark, or pilot light, such as on a water
heater or on other appliances.
Hauling Safety
•
Use care when loading or unloading the machine.
•
Secure the machine from rolling.
Cleaning under the Machine
Service Interval: Before each use or daily
WARNING
The machine may dislodge material from under the
machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle) when the engine is running.
• Do not allow bystanders in the area.
For best results, clean the machine soon after you have
completed mowing.
1. Move the machine onto a flat paved surface.
2. Shut off the engine and wait for all moving parts to
stop before leaving the operating position.
3. Lower the machine to its lowest cutting-height setting;
refer to
Adjusting the Cutting Height (page
4. Wash out the area under the rear door where the
clippings go from the housing to the grass bag.
Note: Wash out the area with the bag-on-demand in
both the fully forward and fully rearward positions.
5. Attach a garden hose that is connected to a water
supply to the washout port
1. Washout port
6. Turn the water on.
7. Start the engine and run it until there are no more
clippings that come out from under the machine.
8. Shut off the engine.
9. Shut off the water and disconnect the garden hose
from the machine.
10. Start the engine and run it for a few minutes to dry the
underside of the machine to prevent it from rusting.
11. Allow the engine to cool before storing the machine
in an enclosed area.
Folding the Handle
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove and save the 2 handle knobs and 2 carriage
bolts from the handle brackets
Important: Route the cables to the outside of the
handle knobs as you fold the handle.
10).
15
(Figure
26).
Figure 26
(Figure
27).
g027458
Publicité
