Steelcase Migration SE Guide Rapide page 23

Scan me! : Factory Reset Aninmation
The following procedure for deactivating/activating
the LOGICisp sensor may only be carried out by
qualified personnel such as the facility manager!
Deactivating/ activating the LOGICisp sensor
1. Press the "1" and "2" and "Up" buttons and hold
for 5 seconds.
=
The letter S and a number (e.g. S4) are shown on
the display.
2. Press the "Up"or "Down" button until S3 is shown
on the display.
=
The display indicates S3.
3. Press the "SAVE" button.
=
The display indicates ON or OFF.
4. Press the "SAVE" button again to confirm.
ü The LOGICsip settings have been saved.
4.3 Sliding desktop
The Migration SE product is also optionally available with a
sliding desktop. The sliding desktop allows easier access to the
cable duct from above the table.
4 Operating and adjusting
EN
23