Steelcase Migration SE Guide Rapide page 27

5.2.2 Table of error messages with the Memory
control panel
Signal/Code
HOT
ISP
CON followed by ERR
For other error messages, please have a look in the detailed user guide on
steelcase.com/eu-en
Message
The overheating
protection circuit has
been activated.
The system has
detected a collision.
The system has
detected a
connection error.
5 Errors and faults
Required measure(s)
Wait until the overheated
components have cooled
down.
Release all buttons and wait
until the drive back function
process is completed.
Release all buttons and wait
5 seconds. Then try again.
Disconnect the power
supply from the mains
connection. Then
disconnect the system from
the power supply. Re-
connect the system and use
it as usual.
EN
27