Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
REVERSING THE DOOR SWING (Cont.)
RE-HANGING THE DOORS (Cont.)
6
hinge pin. Be sure the washer is in place
on the pin.
Hinge
Pin
6.2.2 Tilt the door towards the cabinet, lifting
the top hinge so the pin fits into the
socket on the top of the door.
styrofoam block shipped with the unit
while tightening top hinge screws. The
door will be slightly inclined up above the
top of the cabinet and the gap between
the doors is even across the front.
18
Plastic
Washer
STYROFOAM
Gap
245D3313P001
DO NOT DISCARD
SEE USE
INSTALL
MANUAL
over-tighten these screws. Tighten them
until they are just snug, and then turn
them another one-half turn.
Top
Hinge
6.2.5 Remove styrofoam block and inspect
gap. Repeat steps 6.2.3 and 6.2.4 until
desired door alignment is achieved.
Hinge
Gap at handles –
parallel or slight
upward incline
49-1000478 Rev. 5
Publicité
