Installation Instructions - Elica Rise 30 Guide D'utilisation, D'entretien Et D'installation

Installation Instructions

Venting Methods
Determine which venting method is best for your application.
Vent system can terminate either through the wall or floor.
Island locations
Front (standard) mounted
blower motor
C
C. Aspiration plate
Built-in cabinet locations
B
A
A. Down vent
Installing the vent system
WARNING
Excessive Weight Hazard
Use two or more people to move and install downdraft vent.
Failure to do so can result in back or other injury.
1. Place cardboard or similar material on top of a flat surface where
you can easily assemble the downdraft vent system.
2. Remove parts packages, downdraft vent and blower box from the
carton.
3. Remove all shipping materials, tape and film from the downdraft
vent and blower box.
4. Install the right and left undercounter mounting brackets to the
vent box. Slide the keyhole slots over the guide tabs and push
the brackets up to set them in place.
A. Vent box
B. Undercounter mounting bracket
Rear mounted blower motor
(Reversible version)
B
A
A. Down vent
B. Cooktop
B. Left vent C. Right vent
A
B
C
D
C. Keyhole slots
D. Guide tabs
Island locations
Vent systems installed under a concrete slab using PVC sewer
pipe.
Front (standard) mounted blower motor
A
C
M
B
L
K
A
Rear mounted blower motor (reversible aspiration plate)
A
M
L
C
K
A. Wall cap
B. 6" (15.2 cm) round metal vent
C.16" (40.6 cm) maximum
D. 6" (15.2 cm) round PVC swer pipe
E. 6" (15.2 cm) round metal vent transi-
tion with damper (supplied)
F. 6" (15.2 cm) round PVC coupling
G. Concrete slab
H. 6" (15.2 cm) round PVC sewer pipe
5. Attach the end cap to the vent box, depending on what vent
position you choose (standard-reversible). Place the tabs into the
mounting slots at each end of the downdraft vent as shown and
push down to lock into place.
A
7
B
D
C
F
H
J I
B
D
C
H
J I
I. 6" (15.2 cm) round 90º PVC sewer
pipe elbow
J. Tightly pack gravel or sand
completely around pipe
K. 6" (15.2 cm) round 90º PVC sewer
pipe elbow
L. 6" (15.2 cm) round PVC coupling
M. 12" (30.5 cm) minimum
B
A. Standard installation cap
B. Reversible installation cap
E
G
E
F
G