Publicité
Les langues disponibles
Les langues disponibles
LOWER ANCHOR INSTALLATION
WARNING!
Unsecured objects can become flying hazards and can cause
serious injury in an accident. If your vehicle is equipped with lower
anchors, Diono always recommends installation utilizing the UAS
connectors with this booster seat.
To improve safety and performance, this booster seat is equipped with a
lower anchorage system that allows secure attachment
to a vehicle's lower anchor locations.
1. Disengage UAS connectors from storage slots and lay
booster seat on its side. While depressing the cam lock
lever, pull UAS connectors away from the booster seat
and extend both straps all the way.
2. Attach both UAS connectors to the vehicle
anchors, starting with the connector that is furthest
from you. For ease of use, make sure open end of
hooks face upward during use.
3. While pushing booster against vehicle seat, pull
one adjuster strap tight and then the other. Make
sure that both UAS connectors are securely attached
to the vehicles lower anchors.
NOTE:
Even with UAS connectors properly attached
and adjusted, child seat will still have movement against
the vehicle seat back and bottom.
14
1-866-954-9786
LOWER ANCHOR REMOVAL & SEAT ADJUSTMENTS
DISENGAGING LOWER ANCHOR INSTALLATION
Follow the previous instructions in reverse order.
1. Reach under the bottom of the booster seat and depress the cam lock
lever while pulling the seat away from the vehicle seat back until the lower
anchor straps are extended all the way.
2. Disconnect UAS connectors from vehicle anchors.
3. Pull lower anchor adjuster straps to recess the UAS connectors into the
back of the booster seat bottom for safe storage.
IMPORTANT:
ADJUSTING THE HEAD SUPPORT
1
The head support height can be adjusted for best fit
to your child and to ensure proper placement of the
Vehicle Shoulder Belt. Squeeze the head support
adjustment lever on the back of the booster seat while
adjusting its height up or down to fit the child.
ADJUSTING BACKREST WIDTH
2
To adjust the width of the seat back, turn the dial on the
back of the backrest clockwise to increase width. Turn
counterclockwise to make the backrest narrower.
NOTE:
securing the booster seat installation using UAS.
3
Do not use UAS if installation interferes with vehicle seat belt.
It may be easier to adjust backrest width prior to
ca.diono.com
15
Publicité
