How To Start Up The Appliance; How To Prepare The Appliance For Use; How To Switch On And Preheat The Appliance; How To Grill And Make Raclette - Rommelsbacher RC 1400 Mode D'emploi

How to start up the appliance

WARNING: Hazard of injury and burns!
• Casing surfaces, grill plate and other accessory parts are
getting hot during use!
• Hot surfaces remain hot for some time even after switch-off!

1.) How to prepare the appliance for use

• Make sure that the ON/OFF switch has been set to position "OFF" and there are no empty
pans on the Raclette level.
• Put the appliance on a heat-resistant, stable and fl at working surface (no lacquered surfaces, no
tablecloths, etc.).
• Place the reversible grill plate on the relevant supports of the appliance. Please take care for the
correct position of the grill plate.
• Plug the mains plug into a suitable socket in order to connect the appliance with the mains supply.
While laying the cord, take care that nobody can get entangled or stumble over the power cord in
order to prevent that the appliance is pulled down accidentally.

2.) How to switch on and preheat the appliance

• In order to switch on the appliance, set the ON/OFF switch to position "ON". The pilot lamp
integrated in the switch lights up continuously.
• Turn the temperature control clockwise to the right to position "MAX". The appliance heats up and
the pilot lamp integrated in the temperature control lights up.
• The pilot lamp is off, as soon as the set temperature is reached. The alternating lighting up and
going out of the pilot lamp during operation shows the thermostatic temperature control.
• Heat up the appliance for at least 10 minutes.
NOTE: At setting "MAX", the appliance is always operating at maximum performance. In general,
there is no clocking of the thermostat.

3.) How to grill and make Raclette

Raclette level
20
Parking level