Publicité
Les langues disponibles
Les langues disponibles
Turn the disk brushes through approxi-
mately 45°.
Remove the disk brushes downwards.
Insert the new disk brushes in reverse
sequence.
Set the advance speed.
Turn the running gear to the rear with
your foot.
Maintenance contract
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
Fault
Appliance cannot be started
Insufficient quantity of water
Poor vacuum performance
Poor cleaning result
Brushes do not turn
12
English
In case of danger of frost:
Empty the fresh and dirt water reser-
voirs.
Store the appliance in a frost-protected
room.
Danger
Risk of injury. Turn the program selection
switch to "OFF" and disconnect the mains
plug before performing any works on the ap-
pliance.
Drain and dispose of dirty water and ex-
cess fresh water.
If a fault cannot be rectified using the table
below, please contact Customer Service.
Faults
Remedy
Check if the mains plug is connected
Check the fresh water level, refill tank if required
Check the hoses for blockages, refill tank if required
Clean the seals between the dirty water tank and cover
and check for tightness, replace if required.
Clean the fluff filter
Clean the vacuum lips on the vacuum bar, replace if re-
quired
Check the suction hose for blockages, clean if required
Make sure the suction hose is leak-tight, clean if required
Check whether the cover on the dirty water discharge
hose is closed
Check the setting of the vacuum bar.
Check the brushes for wear, replace if required
Check whether the brushes are blocked by any foreign
substances, remove if required
Frost protection
Faults
Publicité
