2-1
Disassembling [3]
Open the locking lever [3-1].
►
Turn the locking lever [3-1] further to
►
wards the end of the handle as far as it will
go and hold it in this position. Pull the sand
ing head and handle apart at the same time.
The sanding head and handle are separate and
can be stored in a Systainer.
Disassemble the extension tubes in the same
way as the handle.
2
3-1
7.2
Connecting
Unauthorised voltage or frequency.
Risk of accidents
► The mains voltage and the frequency of the
power source must correspond to the
specifications on the name plate.
► In North America, only Festool machines
with the voltage specifications 120 V/60 Hz
may be used.
hold
WARNING
English
3
11