Publicité
Les langues disponibles
Les langues disponibles
E
1¾" (45 mm)
Installation with horizontal panel
If there is no oven beneath the cooktop, install a horizontal
panel. To allow access to the power supply connection
and regulator maintain a minimum clearance of ⅜"
(10 mm) from the edges of the panel (F).
IMPORTANT: Complete the installation of the cooktop
before installing the horizontal panel.
Installation above a drawer
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
min. 0" (0 mm)
E
1¾" (45 mm)
F
min. ⅜" (10 mm)
Installation above a cabinet door
A
min. ¾" (19 mm)
max. 2" (50 mm)
B
5⅞" (150 mm)
C
2¾" (70 mm)
D
min. 0" (0 mm)
E
1¾" (45 mm)
F
min. ⅜" (10 mm)
G
min. 1" (25)
Installation procedure
4 Installation procedure
Follow these instructions to install the cooktop into the
Installation procedure
countertop.
CAUTION
Sharp edges.
Use protective gloves when installing the appliance.
▶
CAUTION
The appliance is heavy.
It is recommended that two people install this appliance.
▶
4.1 Preparing the cooktop
Requirement: IMPORTANT: A foam tape seal is factory
installed on the underside of the cooktop to prevent leaks.
Do not remove the seal under any circumstances.
Place the cooktop face down on a soft and stable
1.
surface. Use the foam sheet from the packaging to
protect surfaces from scratching.
Attach the hold-down brackets to the underside of the
2.
cooktop with the provided short screws. Loosely tighten
the screws so the clamps do not move freely. Rotate
the hold-down brackets so that the appliance can be
placed in the cutout.
Note: The rating plate will not be accessible after
installation. Make a note of your appliance's details or
refer to the enclosed appliance certificate.
4.2 Installing the pressure regulator
WARNING
Do not attempt any adjustment of the pressure regulator,
except when converting to propane. Adjustments could
lead to leaks or cause incorrect gas pressure to the
appliance.
Installation procedure en-us
9
Publicité
