Bosch NGM3051UC Instructions D'installation page 14

en-us Conversion to LP gas
5 Conversion to LP gas Conversion to LP gas
Your appliance is equipped for use with natural gas on
Conversion to LP gas
delivery. It can be converted to LP gas supply.
The components required for conversion to LP gas are
contained in the LP conversion kit included with this
appliance, or are available from Customer Service.
→ "Customer Service", Page 16
Only a qualified technician or installer is authorized to
convert the appliance to another gas type.
Before carrying out the conversion, turn off the electricity
and gas supply.
5.1 Converting the pressure regulator
WARNING
Turn off the electricity and gas supply before carrying out
the conversion.
Locate the pressure regulator on the bottom right end of
1.
the appliance.
Remove the hexagon shaped conversion cap from the
2.
regulator. Make sure not to dislodge the gasket
the cap or the spring
14
inside the regulator.
Grasp the plastic orifice stem
3.
forcefully from the conversion cap
snugly into an indent in the cap and may require a
strong pull to remove. It may be helpful to gently "rock"
the plastic stem while pulling it from the metal cap.
Rotate the stem 180°
4.
a Confirm that the button end of the orifice stem is away
from the conversion cap.
a Confirm that the letters "LP" on the orifice stem are
upside down when the conversion cap is set flat on its
head.
Snap the orifice stem back in place in this position
5.
inserting it into the indent in the conversion cap
Insert the hexagon cap back into the regulator and
6.
tighten, do not over-tighten.
IMPORTANT: Attach the metallic sticker included with
7.
the LP conversion kit to the bottom of the appliance as
shown. This sticker provides notice that the appliance
has been converted for use with LP gas. It should be
located near the appliance rating plate.
→ "Rating plate location", Page 16
on
Note: If you change the type of gas back to natural gas
at a later point, remove the sticker.
firmly and pull it
. The stem snaps
⁠ .
⁠ .