Publicité
Les langues disponibles
Les langues disponibles
(2) Wind speed and wind direction adjustment and fan operation
When you want to change the wind speed
I While the air conditioner is operating, press the [FAN SPEED] button
5.
• Each time the button is pressed, the setting changes as shown be-
low.
The wind speed is displayed at 5.
• The following wind speeds can be selected:
Wind speed
4-speed model
3-speed model
2-speed model
* The wind speeds that can be selected depend on the model.
NOTES
- In cases such as the following, the liquid crystal display and unit wind
speed are different:
1. When "HEAT STAND BY" or "DEFROST" is displayed.
2. Immediately after heating operation (while waiting for mode selec-
tion)
3. When the room temperature is higher than the set temperature in the
heating mode.
4. Dry operation
- For 3-speed models, a central controller wind speed display and the
remote controller wind speed display may be different.
CENTRALLY CONTROLLED
DRY COOL
DAILY
AUTO OFF
AUTO FAN
CHECK
SET TEMP.
HEAT
STAND BY
DEFROST
SET TEMP.
MODE
TIMER
TIMER SET
PAR-F27MEA-US
Remote controller display
(Low) (Mid1)
(Mid2)
(High)
FAN
FAN
FAN
FAN
SPEED
SPEED
SPEED
SPEED
(Mid1)
(Mid2)
(High)
FAN
FAN
FAN
SPEED
SPEED
SPEED
(Mid1)
(High)
FAN
FAN
SPEED
SPEED
1Hr.
SENSAOR
AUTO
AUTO
TIMER
INSIDE
ON
OFF
FAN
CLOCK
SPEED
REMAINDER
FILTER
CHECK MODE
VENTILATION
TEST RUN
ERROR CODE
NOT AVAILABLE
LIMIT TEMP.
ON/OFF
CLOCK→ON→OFF
FUN SPEED
AIR DIRECTION
FILTER
LOUVER
VENTILATION
CHECK TEST
When you want to change the wind direction
I While the air conditioner is operating, press the [AIR DIRECTION]
button 6.
• Each time the button is pressed, the setting changes as shown be-
low.
The wind direction is displayed at 6.
• The following wind directions can be selected:
Display
Operation
Wind
mode
Speed
High/Mid1
Heat/fan
Mid2/Low
High
Cool
Mid1/Mid2/Low
Not
Dry
settable
Airflow
setting
when operation
mode was changed
* After one hour, automatically returns to the horizontal position.
* During swing operation, remote controller display and airflow vane po-
sition cannot be synchronized.
* There may not be an airflow function, depending on the model.
NOTE
- In cases such as the following, the liquid crystal display and unit airflow
may be different.
1. When "HEAT STANDBY"or "DEFROST" is displayed
2. Immediately after heating operation (Waiting for mode selection)
3. When the room temperature is higher than the set temperature in
the HEAT mode
5
6
1
1
5
6
Setting 1
Setting 2
Swing
(horizontal 0˚)
(horizontal 45˚)
(horizontal 60˚)
Horizontal
Downward
Downward
Swing
outlet
45˚
Horizontal outlet
Downward 45˚
Downward 60˚
Swing
* Horizontal after 1 hour
Cool
Dry
–
–
Fan
operation
Setting 3
Setting 4
(horizontal 85˚)
Downward
60˚
85˚
Downward 85˚
Heating
–
operation
4
Publicité
