Publicité
Les langues disponibles
Les langues disponibles
3
How to Operate
(1) On/off and operation mode selection and room temperature adjustment
3
2
3
2
When starting operation
I Press the [ON/OFF] button 1.
• The ON lamp 1 and display light.
The restarting operation contents are shown below.
NOTE
Operation
mode
Temperature
setting
Wind speed
Airflow
When stopping operation
I Press the [ON/OFF] button 1.
• The ON lamp 1 and display go off.
When selecting the operation mode
I Press the [MODE] button 2 while the air conditioner is operating.
• The setting is switched each time the button is pressed.
The operation mode is displayed at 2.
COOL
DRY
NOTE
The auto and heating functions may not be installed, depending on the
outdoor unit model.
CENTRALLY CONTROLLED
DRY COOL
AUTO OFF
AUTO FAN
CHECK
HEAT
STAND BY
DEFROST
SET TEMP.
MODE
TIMER
PAR-F27MEA-US
Remote controller settings
Last operation mode
Last set temperature
Last set wind speed
COOL
Horizontal
DRY
outlet
Operation
HEAT
Last setting
mode
Horizontal
FAN
outlet
FAN
AUTO
HEAT
1Hr.
SENSAOR
DAILY
AUTO
AUTO
TIMER
INSIDE
ON
OFF
FAN
CLOCK
SPEED
SET TEMP.
REMAINDER
FILTER
CHECK MODE
VENTILATION
TEST RUN
ERROR CODE
NOT AVAILABLE
LIMIT TEMP.
ON/OFF
CLOCK→ON→OFF
FUN SPEED
AIR DIRECTION
FILTER
LOUVER
VENTILATION
CHECK TEST
TIMER SET
When you want to change the set temperature
<When you want to lower the room temperature>
I Press the [SET TEMP. (
<When you want to raise the room temperature>
I Press the [SET TEMP. (
• The set temperature changes 2 °F each time the button is pressed.
The set temperature is displayed at 3.
• The following specified temperatures can be set:
Cool/dry
operation
67 to 87 °F
NOTE
When "LIMIT TEMP." is displayed on the screen, the specified tempera-
ture range is limited. Therefore, the temperature range that can be
changed becomes narrow.
Room temperature display
During operation, the intake temperature is displayed at 4.
NOTES
- The display range is 45 to 102 °F. When this range is exceeded, the
room temperature display flashes at 45 °F or 102 °F.
- When multiple indoor units are controlled, the contents of the master
indoor unit are displayed on the remote controller.
- The room temperature sensor position can be selected from "INDOOR
UNIT" and "REMOTE CONTROLLER".
The initial setting is "INDOOR UNIT". When you want to change the
room temperature sensor position to "REMOTE CONTROLLER", con-
sult your dealer.
- When "no room temperature display" was selected by remote control-
ler function selection, the room temperature is not displayed.
4
1
1
)] button 3.
)] button 3.
Heat operation
Auto operation
63 to 83 °F
67 to 83 °F
Fan
Cannot be set.
3
Publicité
