Publicité
Les langues disponibles
Les langues disponibles
2
Part Names
"CENTRALLY CON-
TROLLED" display
Displayed when air conditioner
operation is prohibitted by a cen-
tral controller, etc. When the re-
mote controller buttons are
locked, this display flashes.
"Set temperature"
display
Displays the set temperature.
(For description purposes, all the
displays are assumed to be on.)
"Operation mode"
Displays the operation mode.
TEMP. buttons
(M) Lower (L) Raise
Timer selection button
Mode selection button
Time selection buttons
(M) Return (L) Ahead
Open the door.
NOTE
When an operation button is pressed, if the indoor unit does not have that function, "NOT AVAILABLE" flashes.
When one remote controller controls multiple indoor units, if the master indoor unit has the selected function, this message is not displayed.
"TIMER" "DAILY"
"AUTO OFF" Display
Displays the timer mode when
the timer is set.
There are three timers modes:
1 day timer, daily timer, and auto
off timer. One of these modes
can be selected.
CENTRALLY CONTROLLED
DRY COOL
DAILY
AUTO
TIMER
AUTO OFF
ON
AUTO FAN
CLOCK
CHECK
SET TEMP.
REMAINDER
HEAT
STAND BY
ERROR CODE
DEFROST
"Airflow" display
Displays the outlet air direc-
tion.
"Wind speed"
display
Displays the selected wind
speed.
"Louver" display
Displays operation of the
swing louver. It is not dis-
played when the louver is
stopped.
DISPLAY SECTION
CENTRALLY CONTROLLED
DRY COOL
DAILY
TIMER
AUTO OFF
AUTO FAN
CLOCK
CHECK
SET TEMP.
REMAINDER
HEAT
STAND BY
ERROR CODE
DEFROST
SET TEMP.
CLOCK→ON→OFF
MODE
TIMER
TIMER SET
PAR-F27MEA-US
OPERATION SECTION
"Current/Starting/
Ending/REMAINING
time" display
Displays the current time and
timer set times.
When the timer is operating, dis-
plays the normal time and the
stating, ending, or remaining
time.
1Hr.
SENSAOR
AUTO
INSIDE
OFF
FAN
SPEED
FILTER
CHECK MODE
VENTILATION
TEST RUN
NOT AVAILABLE
LIMIT TEMP.
"Room temperature"
display
Displays the intake temperature
while the air conditioner is op-
erating.
"Set effective for 1 hr."
display
Displayed when low downward
is selected at cooling and elec-
tronics dry operation.
(Differs with the model.)
After one hour, the display goes
off, and swing also switches.
1Hr.
SENSAOR
AUTO
AUTO
INSIDE
ON
OFF
FAN
SPEED
FILTER
CHECK MODE
VENTILATION
TEST RUN
LIMIT TEMP.
NOT AVAILABLE
ON/OFF
FUN SPEED
AIR DIRECTION
FILTER
LOUVER
VENTILATION
CHECK TEST
"Senser" display
Displayed when the remote
controller sensor is used.
"FILTER" display
Indicates that it is time to
clean the filter.
"LIMIT TEMP." display
Displayed when the set tem-
perature range is controlled by
remote controller functions se-
lection.
" " display
Displayed while the power is on.
"NOT AVAILABLE"
display
When the button of a function
that is not installed at the indoor
unit was pressed, this display
flashes simultaneously with the
corresponding function display.
ON/OFF lamp
ON/OFF button
Wind speed button
FILTER button
CHECK button
(Normally not used)
TEST RUN button
(Normally not used)
Airflow button
Louver button
Built-in temperature sensor position
2
Publicité
