Haier HPD10XCM Guide De L'utilisateur page 9

English
Control Panel Operation
BE: 'BB, S SS
(1) ©) Power On / Off
(2) ©) Mode: Press the mode button for desired setting.
Cool: |3<| sign appears in LCD display when in cooling
Dehumidification: [4] sign appears in LCD display when in dehumidification mode.
Fan: [$] sign appears in LCD display when in fan mode.
(3) ($) Fan Speeds There are 3 adjustable speeds in the cool and fan mode:
Low, Medium and High. In dehumidification mode, and room temperature is greater than 77°F, fan
speed can be adjusted; otherwise fan speed is fixed to "low."
(4) On / Off Timer: The timer can be used to automatically turn on or off the air conditioner.
To automatically turn on the air conditioner, set the timer while the power control is in
the OFF position.
1. Turn off the air conditioner.
2. Press the Timer button.
3. Press the (A) or (v) button to change the delay start time from 1 to 24 hours.
4. The delay start time will display on the control panel.
To automatically turn off the air conditioner, set the timer while the power control is in the
ON position.
1. Turn on the air conditioner.
2. Press the Timer button.
3. Press the (A) or (M) button to change the delay stop time from 1 to 24 hours.
4. The delay stop time will display on the control panel.
To clear the timer setting:
1. The power control can be either in the on or off position.
2. Press the Timer button.
3. Press and hold the (v) button until the timer display has been cleared.
(s) (N Time / Temperature Set Control: The (4) and (v) buttons can be used for adjusting the timer
and temperature settings.
© To set the timer: See "On / Off Timer" instructions above.
To set the temperature: While in the Cool mode, press the (A) or M button to raise or lower the
temperature. The set temperature is displayed and may be adjusted. The temperature can be set
between 61° F and 89° F (Cool mode). After 15 seconds the display will revert back to the
room temperature.
NOTE: The temperature cannot be adjusted in the fan or dehumidification modes.
(7) lal When the red indicator flashes, the internal water tank has filled with condensed water
and the air conditioner will turn off automatically. See the "OPERATION, DURING USE" section
for directions on draining the water from the air conditioner.