Agilent Technologies X3500-64000 Mode D'emploi page 290

17 Technical Information
Connection of the High Vacuum Flange
7
8
9
10 Plug the line cord and connect the pump cable to the pump;
11 Connect the mating connector with the jumper on the interlock
Figure 53
Connection of the High Vacuum Flange
In the case the rotor is suddenly blocked, the torque arising from the
system and the high vacuum flange must be absorbed. Only the
components listed in the following can be used to fasten the pump to
the high vacuum flange.
290/304
Rotate the bracket until the controller is on the chosen position;
Tighten the screws properly;
Turn the pump again;
signal to start the pump.
Mounting 2
TwisTorr 304 FS User Manual / 87-901-027-01(B)