GreenWorks G24LT25 Manuel Opérateur page 6

EN
1 DESCRIPTION
1.1 PURPOSE
This machine is used to cut grass, light weeds, and other
similar vegetation at or around ground level. The cutting
plane must be approximately parallel to the ground surface.
You cannot use the machine to cut or chop hedges, shrubs,
bushes, flowers and compost.
1.2 OVERVIEW
Figure 1 - 17.
Trigger
1
Lock-out button
2
Upper shaft
3
Auxiliary handle
4
Middle shaft
5
Lower shaft
6
Motor housing
7
Edge guide
8
Trimmer head
9
Guard
10
Release button
11
Positioning hole
12
Knob
13
Battery release button
14
Cut-off blade
15
Tab
16
Spool cover
17
Spool
18
Spool housing
19
Eyelet
20
Anchor hole
21
Guide slot
22
Direction of rotation
A
Best cutting area
B
Dangerous cutting area
C
1.3 PACKING LIST
1 String trimmer bare
tool
2 Auxiliary handle
assembly
2 SAFETY
Make sure that you follow all safety instructions.
Refer to Safety Manual.
3 Guard assembly
4 Operator manual
WARNING
English
3 INSTALLATION
3.1 UNPACK THE MACHINE
Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If you do not have all the parts, do not operate the
machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
For your personal safety, do not insert battery before the
tool is assembled completely.
3.2 ATTACH THE EDGE GUIDE
Figure 2.
The edge guide can limit the cutting range of the machine
and decrease the risk of the damage caused by the rotating
cutting line.
1. Push the edge guide onto the trimmer head until it
engages in the slots.
2. The edge guide can be flipped up for storage.
3.3 ATTACH THE GUARD
Figure 3.
Do not touch the cut-off blade.
1. Remove the screws from the trimmer head with a Phillips
head screwdriver (not included).
2. Put the guard onto the trimmer head.
3. Align the screw holes on the guard with the screw holes
on the trimmer head.
4. Tighten the screws.
4
WARNING
WARNING
WARNING
NOTE
WARNING