Publicité
Les langues disponibles
Les langues disponibles
DANGER: To reduce the risk of serious personal injury, turn unit off and disconnect it from power source
before making any adjustments or removing/installing attachments or accessories. An accidental start-up can
cause injury.
For assistance with your product call BLACK+DECKER at 1-800-544-6986.
PROBLEM
Mower doesn't run when bail handle
is activated
Motor stops while mowing
Mower runs but cutting performance is
unsatisfactory, or does not cut entire lawn
Mower is too hard to push
Mower is abnormally noisy and vibrates
Mower not picking up clippings with bag
TROUBLESHOOTING GUIDE
SOLUTION
Check to make sure mower is properly plugged in and that the button on switch box is being completely
depressed before pulling the bail handle.
Release bail handle to turn mower off. Unplug mower. Turn mower over and check that blade is free to
turn.
Release bail handle to turn mower off. Unplug mower. Turn mower over
and check that blade is free to turn.
Raise cutting height of wheels to highest position and start mower.
Avoid overloading the mower. Slow down the cutting pace, or raise the cut height.
Release bail handle to turn mower off. Turn mower over and check:
Blade for sharpness - Keep blade sharp.
Deck and discharge chute for clogging.
Wheel height adjustment may be set too low for grass condition. Raise cutting height.
Release bail handle to turn mower off. Unplug mower. Raise cutting height to reduce deck drag on grass.
Check each wheel for free rotation.
Release bail handle to turn mower off. Unplug mower. Turn mower on side and check blade to ensure it
has not been bent or damaged. If blade is damaged, replace with a BLACK+DECKER replacement blade. If
the underside of the deck is damaged, return mower to a BLACK+DECKER Authorized service center.
If there is no visible damage to the blade and the mower still vibrates: Release bail handle to turn
mower off, unplug mower, disassemble entire blade assembly as described in the Removing and
Installing Blade section. Remove any debris and clean each piece. Replace each piece as described
in the Removing and Installing Blade section. If mower still vibrates, return the mower to an
authorized BLACK+DECKER authorized service center.
Chute clogged. Release bail handle to turn mower off. Unplug mower. Clear chute of grass clippings.
Raise cutting height of wheels to shorten length of the cut.
Bag full. Empty bag more often.
English
11
Publicité
