Publicité
Les langues disponibles
Les langues disponibles
4. Wear proper eye protection and gloves and be careful
not to cut yourself.
5. Carefully file the cutting edges of the blade with a fine
tooth file
33
or sharpening stone, maintaining the
angle of the original cutting edge.
6. Check balance of blade. See instructions for
Blade Balancing.
7. Replace blade on mower and tighten securely.
Fig. N
33
Blade Balancing (Fig. O)
Check balance of the blade
the blade over a nail or round screwdriver
horizontally in a vise
23
. If either end of the blade rotates
downward, file along the sharp edge of that dropping end.
Blade is properly balanced when neither end drops.
Fig. O
24
23
Storage (Fig. A, P)
WARNING: Rotating blade can cause serious injury.
Release bail handle to turn mower off and unplug
mower before lifting, transporting, or storing the
mower. Store in a dry place.
CAUTION: Pinch point. To avoid being pinched,
keep fingers away from area between handles when
folding down handles.
CAUTION: Make sure cord does not become stretched
or pinched in the joints of the handles during folding.
This can cause damage to the cord.
The handle of the mower can be easily folded down for
quick and convenient storage.
1. Holding onto the handle, open, but do not remove, the
lower-handle attachment knobs
to the front of the mower.
22
22
by placing center hole in
24
, clamped
6
and fold the handle
2. Open, but do not remove, the upper handle attachment
knobs
5
, or loosen the knobs, and fold the upper
handle
3
back over the lower handle
3. The mower shold be compacted down as shown in
Figure P.
Fig. P
23
Accessories
WARNING: Since accessories, other than those
offered by BLACK+DECKER, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
22
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact BLACK+DECKER
1-800-544-6986.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Repairs
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including power cord repairs, and brush inspection
and replacement, when applicable) should be
performed by a BLACK+DECKER factory service center
or a BLACK+DECKER authorized service center. Always
use identical replacement parts.
4
.
3
4
5
English
6
9
Publicité
