Publicité
Les langues disponibles
Les langues disponibles
WARNING
Leaking coolant and oil!
Fire. The coolant contained in the appliance is eco-friendly,
but also flammable. The oil contained in the appliance
is flammable. Escaping coolant and oil can ignite if the
concentration is high enough and in contact with an
external heat source.
u Do not damage the pipelines of the coolant circuit and
the compressor.
WARNING
Fire hazard and danger of damage!
u Do not place appliances emitting heat e.g. microwaves,
toasters etc. on the appliance!
NOTICE
Risk of damage.
An incorrect Side-by-Side- (SBS) assembly leads to conden‐
sate between the appliances. Assemble the V-Zug appli‐
ances as follows:
u Install the freezer next to the refrigerator.
NOTICE
Covered vents!
Damage. Appliance can overheat, which can reduce the
service life of various parts of the appliance and lead to
operational impairments.
u Always make sure there is good ventilation.
u Always keep vents or ventilation grids in the appliance
housing and in the kitchen furniture (fully integrated
appliance) unobstructed.
u Always keep the fan air vents unobstructed.
In the event that the appliance is damaged, contact the
q
supplier immediately before connecting to the mains.
The floor at the site must be flat and level.
q
Do not install the appliance in a location where it is
q
exposed to direct radiation of the sun, next to a cooker,
heater and similar.
Do not install the appliance alone: it is best to work
q
together with two or more people.
The more refrigerant there is in the appliance, the larger
q
the space that it is installed in must be. If the space is
too small, any leak may create a flammable mixture of
gas and air. For every 8 g of refrigerant, the installation
space must be at least 1 m
coolant can be found on the type plate inside the appli‐
ance.
If the appliance is installed in a very damp environment,
q
condensed water may form on the outside of the appli‐
ance. Always make sure that there is good ventilation -
both at air inlet and outlet - at the site of installation.
After installation:
u Remove protective films, adhesive tapes and transport
lock parts etc.
Note
u Clean the appliance (see Operating Instructions, Chapter
"Cleaning the appliance").
* Depending on model and options
3
. Information regarding the
Appliance dimensions
4 Appliance dimensions
Fig. 1
5 Recess dimensions
This is a base unit and should be installed under a worktop.
The kitchen units must be fitted according to the specifi‐
cations, allowing sufficient ventilation to ensure the equip‐
ment works properly.
Fig. 2
The specified energy consumption applies to a unit depth of
560 mm. The appliance will work properly at a unit depth of
550 mm, but at a slightly higher energy consumption.
33
Publicité
