Beta Motorcycles RR 200 2T EUROPA Mode D'emploi page 140

4
EN
1
2
3
KEY TO SYMBOLS
Tightening torque
Threadlocker Medium
Grease
ENGINE OIL
CHECK THE LEVEL
Hold the vehicle upright.
Position the drive on a flat base ensuring
stability.
Remove the inspection cap 1.
The oil level must arrive to the lower edge
of check hole.
Otherwise restore the oil level through
plug 2.
The inspection cap is ONLY to check
the oil level. For the oil drain, refer to the
paragarafo Replacement on page 52.
Use the oil indicated on page 16 in
the "Recommended lubricants and liquids"
table.
To facilitate this, it is recommended to
remove spring 3.
50