Publicité
Les langues disponibles
Les langues disponibles
English
LED Worklight (Fig. A)
CAUTION: When using the worklight for purposes
other than screwdriving or drilling be sure to
remove all accessories. Unused accessories could
cause injury or property damage.
CAUTION: Do not stare into the LED. Serious eye
injury could result.
When the screwdriver is activated by pulling the trigger
switch
3
, the LED worklight
The LED worklight will go off when the trigger is released.
Performing an Application (Fig. A, F)
The forward/reverse slider
the tool and also serves as a lock off button.
1. Insert and secure the appropriate bit or accessory into
the chuck
.
6
2. Grasp the screwdriver as shown in Figure F.
3. The screwdriver is turned on and off by squeezing and
releasing the trigger switch
4. To select forward rotation, release the trigger switch and
slide the forward/reverse slider
5. To select reverse rotation, slide the forward/ reverse
slider
2
the left.
nOTE: The center position of the forward/reverse
slider
2
locks the trigger switch
When changing the position of the forward/reverse
slider
2
, be sure the trigger switch is released.
nOTE: For best performance, #8, 2" and smaller fasteners
are recommended, or screw into pre-drilled holes.
NOTE: When the screwdriver is activated by squeezing
the trigger switch
3
, the LED worklight
automatically illuminate.
MAINTENANCE
WARNING: To reduce the risk of serious
personal injury, turn unit off before making any
adjustments or removing/installing attachments
or accessories. An accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this procedure.
WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
8
4
will automatically come on.
2
determines the direction of
3
.
2
to the right.
3
in the off position.
4
will
Accessories
WARNING: Since accessories, other than those
offered by BLACK+DECKER, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
BLACK+DECKER recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact BLACK+DECKER call
1-800-544-6986 .
Repairs
The battery pack is not serviceable. There are no serviceable
parts inside the tool or battery pack.
WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement, when
applicable) should be performed by a BLACK+DECKER
factory service center or a BLACK+DECKER authorized
service center. Always use identical replacement parts.
RegisterOnline
Thank you for your purchase. Register your product now for:
•
WARRAnTY sERViCE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
COnFiRMATiOn OF OWnERshiP: In case of
•
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
•
FOR YOUR sAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
•
Register online at www.BlackandDecker.com/
NewOwner
Publicité
