Monacor SAM-502 Mode D'emploi page 7

4) Adjust the tone with the controls (20). The controls
influence both outputs REC (8) and OUT (9).
5) For an optimum console lighting a gooseneck con-
sole lamp 12 V/3 W (e. g. MONACOR GNL-200,
not included) can be connected to the LAMP jack
(11).
5 Pre-Fader Listening (Monitor)
The channels 1-4 can individually be monitored via
headphones. If the corresponding fader is set to mini-
mum, by this the most favourable point of time for
fading in a signal source can be chosen.
1) For this connect headphones (≥ 8 Ω) to the
PHONES jack (12).
2) Choose the channel to be monitored with the but-
tons (18).
3) Adjust the headphones volume with the control
MON LEVEL (19).
Attention! Never adjust the headphones volume
too high. Permanent high volumes may damage a
person's hearing. The hearing gets accustomed to
high volumes which after some time do not seem to
be so high. Therefore do not further increase a high
volume after getting used to it.
6 Microphone Announcement
For the microphone adjust the volume with the fader
(16). For better intelligibility of a microphone an-
nouncement the music level of the channels 1-4 will
be attenuated by 12 dB with the talkover switch (1).
7 Specifications
Inputs
MIC: . . . . . . . . . . . . . . . 1 mV/600 Ω
PHONO mag.: . . . . . . . . 3 mV/50 kΩ
CD / TUNER / TAPE / VIDEO: 150 mV/100 kΩ
Outputs
OUT: . . . . . . . . . . . . . . . 0.775 V/600 Ω
REC . . . . . . . . . . . . . . . 0.775 V/600 Ω
Frequency range: . . . . . . . 20-20 000 Hz
THD: . . . . . . . . . . . . . . . . . 0.1 %
S/N ratio: . . . . . . . . . . . . . . 65 dB
Bass/treble . . . . . . . . . . . . 100 Hz/10 kHz, ±10 dB
Headphones output . . . . . . ≥ 8 Ω, stereo
Talkover: . . . . . . . . . . . . . . -12 dB
Power supply: . . . . . . . . . . 230 V~ /50 Hz/12 VA
Dimensions (WxHxD): . . . . 338 x 11 x 215 mm
Weight: . . . . . . . . . . . . . . . 2.4 kg
According to the manufacturer.
Subject to technical change.
Front panel
338 x 156 mm
GB
7