Waterpik WF-03 Mode D'emploi page 6

6
GETTING STARTED
1
2
3
4
Fill
Eject
High
Low
Off
All manuals and user guides at all-guides.com
Inserting Batteries
1. Remove water reservoir.
2. Twist battery door left from the locked position to unlocked position
and pull battery door away from the unit.
3. Insert 3 AA batteries as shown.
4. To replace battery door, line-up arrows, push and twist.
Replace batteries when there is a noticeable change in performance.
Filling the Reservoir
Lift the flip top on reservoir and fill the reservoir with lukewarm water.
Inserting and Removing Tips
Insert tip into the center of the knob at the top of the Water Flosser handle.
The colored ring will be flush with the end of the knob if the tip is correctly
locked into place. To remove the tip from the handle, press the tip eject
button and pull tip from handle.
Adjusting the Pressure Setting
You can adjust the pressure setting on your Water Flosser by simply sliding
the pressure/power switch on the handle. Slide power switch up 1 click for
low (l) pressure and 2 clicks for high (ll) pressure.
Recommended Technique
Lean low over sink and place the tip in mouth. Aim the tip toward teeth, and
turn the unit ON (l).
For best results, start with the back teeth and work toward the front teeth.
Glide tip along gumline and pause briefly between teeth. Continue until you
have cleaned the inside and outside of both the upper and lower teeth.
Direct the jet stream at a 90-degree angle to your gumline. Slightly close
lips to avoid splashing but allow water to flow freely from mouth into the
sink. Keep unit upright during use for best results.