Publicité
Les langues disponibles
Les langues disponibles
English
(c) Install the hook and spring on the other side
and securely fasten with screw. (Fig. 8)
NOTE:
Pay attention to the spring orientation. Install
the spring with larger diameter away from
you. (Fig. 8)
(3) Using the bit holder
Installing the bit
Slide the bit from the side in the direction of Fig.
9, and then insert firmly until the groove on the
bit locks in the protruded section of the hook.
Removing the bit
Securely hold the main unit and pull out the bit
by holding the tip with your thumb. (Fig. 10)
CAUTION:
G
The bit may come loose from the hook and cause
bodily injury when reversing the direction of the
bit as shown in Fig. 9 or when using the driver
with the bit stored incomplete.
G
Only Hitachi STANDARD ACCESSORIES phillips
bit (No. 2 × 55L; Code No. 318236) may be used.
Do not use other bits since they may come loose.
WARNING:
2. Mounting and dismounting the bit
Loosen
Sleeve
Tighten
Fig. 11
18
To ensure safe use of these products, read the manual for the power
tool used with this hook to obtain all the necessary information.
(1) Mounting the bit
Loosen the sleeve by turning it toward the left (in the
counterclockwise direction as viewed from the front)
to open the clip on the keyless chuck. After inserting a
driver bit, etc., into the keyless drill chuck, and tighten
the sleeve by turning it toward the right (in the
clockwise direction as viewed from the front). (See Fig.
11)
NOTE: If the sleeve becomes loose during operation,
Screw
tighten it further.
The tightening force becomes stronger when the
sleeve is tightened.
Larger diameter faces away
Fig. 8
Groove
Protruded section
Fig. 9
Fig. 10
Publicité
