Operation - Ryobi bg612 Manuel D'utilisation

 Install bolt through the holes in the spark deflector with
LED assembly and spark shield.
NOTE: Orient the bolt so that the head of the bolt sits in
the recessed area of the spark shield.
 Reinstall spark shield knob onto the bolt. Tighten securely.
MOUNTING SPARK SHIELD ASSEMBLY
See Figure 5, page 12.
 Attach the spark shield assembly to the wheel guard using
two screws, washers, and lock washers.
 Tighten screw securely.
 Repeat above steps for the second spark shield assembly.
NOTE: The spark shield assemblies can be installed
on either side of the tool. For detailed grinding, it's
recommended to place the spark shield with magnifier
on the right side above the finer wheel.
MOUNTING WORK RESTS
See Figure 6, page 12.
 Unscrew and remove the work rest knob from the carriage
bolt.
 Attach the right work rest to the inside of the wheel guard
as shown.
NOTE: As the diameter of the wheel decreases with use,
adjust the distance between the wheel and the right work
rest to maintain 1/16 in. or less separation.
 Tighten work rest knob securely.
 Repeat above steps for the left work rest.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
ASSEMBLY
INSTALLING/REMOVING BATTERIES
See Figure 7, page 12.
Always turn the on/off switch to the OFF position when
installing batteries.
 Remove battery covers from the spark shield assemblies.
 Install AAA batteries according to the polarity indicators
(+ or -) inside the battery compartments.
 Replace and secure the battery covers.
MOUNTING GRINDER TO WORKBENCH
See Figure 8, page 12.
The bench grinder must be mounted to a firm supporting
surface such as a workbench or leg stand. Four bolt holes
have been provided in the tool's base for this purpose. Each
of the four mounting holes should be bolted securely using
machine bolts, lock washers, and hex nuts (not included).
Bolts should be of sufficient length to accommodate the
saw base, lock washers, hex nuts, and the thickness of the
workbench. Tighten all four bolts securely.
Carefully check the workbench after mounting to make
sure that no movement can occur during use. If any tipping,
sliding, or walking is noted, secure the workbench to the
floor before operating.
WARNING:
Always make sure your bench grinder is securely
mounted to a workbench. Failure to do so could result in
an accident resulting in possible serious personal injury.

OPERATION

WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
CAUTION:
Excessive pressure on a cold wheel may cause the wheel
to crack.
NOTICE:
Never sharpen or grind anything made of aluminum,
brass, or copper.
8 − English