Publicité
Les langues disponibles
Les langues disponibles
5.3. Disassemble the pedestal
Installation steps
Keep the removed parts.
All the removed parts are
necessary when you assemble
the pedestal.
The screw on one side is pre-in-
4
stalled to the correct position.
When you install charging stations
on both sides, unscrew the screw
on the other side to the same
measure. We recommend that you
use thread-locking compound.
8 mm
26 / 52
M5x10
LERAK136-FRENIT/20230502
2 ... 3 Nm
Remove the top cover
1
fastening screws 4 pcs.
Remove the top cover.
Remove the side profiles
2
2 pcs.
Remove the plastic insulation.
3
Installing one charging station:
5
•
Use fastening screws 2 pcs which
are in the included accessory bag.
Installing two charging stations:
•
Remove the pre-installed screws
2 pcs.
•
These screws are necessary when
you attach the second charging
station to the pedestal.
M5x20
2 ... 3 Nm
Publicité
