Dorman 747-303 Manuel D'installation

747-303
POWER SLIDING
DOOR MOTOR
BEFORE YOU BEGIN:
• Always wear proper safety
equipment when performing repairs.
• Ensure at your point of purchase
that this part fits your exact
vehicle configuration.
• Reference the appropriate service
manual for your vehicle. If you do
not have a service manual, and do
not have the training or experience
to perform the necessary
procedures correctly, seek the
services of a qualified technician.
NEED HELP?
Please call our Technical Support
team for assistance from our team of
certified automotive experts.
1-866-933-2911
© 2023 No reproduction in whole or in part without prior written approval.
747-303_Tech-Note
The OE circuit board needs to be
transferred to the new power sliding
door motor. This retains the OE
anti-pinch functionality, while saving
an unnecessary purchase by not
having to buy a new circuit board. The
board is not prone to failure.
Transfer the circuit board after
removing the OE power sliding door
motor, but before installing the
replacement motor.
CIRCUIT BOARD
TRANSFER
STEP 1:
Remove retaining screw.
STEP 2:
Using a pick, remove circuit
board cover.
Dorman Products, Inc. Corporate Office and Customer Service: 1-800-523-2492.
Disclaimer: Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible
circumstances or situations. Please consult with a qualified auto technician before attempting to perform any work you are not qualified to
do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in property damage
or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor
Vehicle Safety Standards by the National Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such
standards and that you do not disable any motor vehicle safety feature.
STEP 3:
Using a pick, disconnect clutch
electrical connector.
STEP 4:
Remove board from housing.
STEP 5:
Installation of board onto new
motor is reverse of removal from old
motor.
PAGE 1 OF 3