Publicité
Les langues disponibles
Les langues disponibles
EN
3.
TRANSPORT AND
HANDLING
3.1 APPLIANCE IDENTIFICATION
When contacting the manufacturer, Victo-
ria Arduino for any reason, always quote
the machine serial number. The machine is
transported on pallets containing several
machines inside boxes secured to the pal-
let by straps. Before performing any trans-
port or handling operation, the operator
must wear safety gloves and footwear, as
well as overalls with elastics. Pallets must
be transported using an adequate lifting
mechanism (fork-lift truck type).
COLLISION OR CRUSHING HAZARD
During the entire handling operation, the
operator must make sure no one or noth-
ing is inside the operating area. Slowly lift
the pallet to about 30 cm from the ground
and move to the loading area. After mak-
ing sure there are no obstacles, persons
or things, proceed with loading. Once at
destination, always using an adequate lift-
ing mechanism (e.g. fork-lift), after making
sure there is no one or nothing within the
unloading area, lower the pallet to about
30 cm from the ground and transport it to
the storage area.
COLLISION OR CRUSHING HAZARD
Before performing the following opera-
tion, make sure the load is in place and is
not likely to fall when the straps are cut.
The operator, wearing safety gloves and
footwear, must now cut the straps and
store the product. To perform this opera-
tion, check the technical characteristics
of the product to determine the weight of
the machine to be stored and take conse-
quent precautions.
POLLUTION DANGER
Once the machine has been freed of the
pallet or container, do not discard these in
the environment - pollution hazard.
All manuals and user guides at all-guides.com
4.
INSTALLATION
AND PRELIMINARY
OPERATIONS
After unpacking, assess that the machine
and its accessories unit are complete,
then proceed as follows:
Place the machine on a flat surface;
Level the machine through the
adjustable feet;
In the preliminary stage, it is advisable to
install a softener (A) on the external part
of the hydraulic system, and then a mesh
filter (B).
In this way impurities like sand, particles
of calcium, rust etc. will not damage the
delicate graphite surfaces and durability
will be guaranteed.
Following these operations, connect the
hydraulic systems (see Fig. 06).
WARNING
Recommended water mains pressure is
[2.3] bar.
WARNING
Avoid throttling in the connecting tubes.
Check the drain pipe (3) eliminates waste.
05
47
Publicité
