Télécharger Imprimer la page
Masquer les pouces Voir aussi pour ASLC50:

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
:
ASLC50, ASLC50FL,
Models
ASF50, ASLC70, ASF70
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
electric shock and injury to person, including the following:
1. Read all instructions before installing or using exhaust fan.
2. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
3. Before servicing or cleaning the unit, switch power off at
service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the
service panel.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-related construction.
5. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA)
and the American Society for Heating, Refrigeration, and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
CAUTION:
FOR GENERAL VENTILATING USE ONLY. DO
NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS
AND VAPORS.
210572120 Rev. D 7-06
All manuals and user guides at all-guides.com
OPERATING MANUAL
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. This unit must be grounded.
9. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off
power unit.
WARNING:
DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL
DEVICE.
10. Acceptable for use over a bathtub or shower when installed
in a GFCI protected branch circuit.
11. NEVER place a switch where it can be reached from a tub or
shower.
WARNING:
www.airkinglimited.com
Exhaust Fan with Light
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
DO NOT USE IN KITCHENS
1 of 12

Publicité

loading

Sommaire des Matières pour AirKing ASLC50

  • Page 1 All manuals and user guides at all-guides.com IMPORTANT INSTRUCTIONS - OPERATING MANUAL ASLC50, ASLC50FL, Models Exhaust Fan with Light ASF50, ASLC70, ASF70 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION.
  • Page 2 All manuals and user guides at all-guides.com INSTALLATION INSTRUCTIONS CAUTION: MAKE SURE POWER IS SWITCHED OFF AT SERVICE PANEL BEFORE STARTING INSTALLATION. Housing SECTION 1 Preparing the Exhaust Fan Joist 1. Unpack fan from the carton and confirm that all pieces are present.
  • Page 3 All manuals and user guides at all-guides.com Supply Ground from house White Hot (Black) Hot (Red) Figure 8 Figure 6 SECTION 4 2. Wiring Fan/Light together: Run wiring from an approved wall switch carrying the appropriate rating. One neutral (white), Ducting one ground (green or bare copper), and one hot (black lead CAUTION:...
  • Page 4 Secure the assembly to the reflector bolt using Tabs the acorn nut and lock washer. Install the appropriate bulb (not included) specific to your model: ASLC50/ASLC70: 100 watt maximum, type A19 medium base incandescent bulb. ASLC50FL: 13 watt maximum, 2 pin quad, compact flourescent bulb.
  • Page 5 All manuals and user guides at all-guides.com Troubleshooting Guide Trouble Probable Cause Suggested Remedy 1. Fan does not operate when the switch is on. 1a. A fuse may be blown or a circuit tripped. 1a. Replace fuse or reset circuit breaker. 1b.
  • Page 6 Polarized Nylon Receptacle 2P 5S1201012 Grill 5S1201016 #10 Machine Screw 5S1201013 Lens 5S1201017 ASLC Motor Clip 5S5201001 Lamp Holder - ASLC50/ASLC70 5S1201018 #10 Lock Washer 5S1999007 Ballast - ASLC50FL 5S1201022 #10 Acorn Nut 5S1999008 Ballast - ASF50/ASF70 5S1201023 Motor - ASLC50/ASLC50FL/ASF50...
  • Page 7 All manuals and user guides at all-guides.com INSTRUCTIONS IMPORTANTES – MANUEL D’OPÉRATION Ventilateur combiner, comprend ASLC50, ASLC50FL, Modéles ASF50, ASLC70, ASF70 lumière et ventilation LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ.
  • Page 8 All manuals and user guides at all-guides.com INSTRUCTIONS D’INSTALLATION AVERTISSEMENT: VOUS ASSURER QUE L’ALIMENTATION EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER Cabinet L’INSTALLATION. SECTION 1 Préparation du Ventilateur d’évacuation Solive 1. Sortir le ventilateur de sa boite et confirmer que toutes les pièces sont présentes.
  • Page 9 All manuals and user guides at all-guides.com d’évacuation. Raccorder le fil de mise à la terre de la maison au fil vert de la vis de mise à la terre du ventilateur (Figure 8). Utiliser des méthodes de raccordement approuvées pour toutes les connexions.
  • Page 10 Onglets sécurité. Installer l’ampoule appropriée (non-compris) spécifique à votre modèle. ASLC50/ASLC70: ampoule incandescente à culot moyen de type A19, 100 watts maximum. ASLC50FL: ampoule de type fluorescent, à 2 tiges quad, compact, de 13 watts maximum.
  • Page 11 All manuals and user guides at all-guides.com Guide de dépannage Trouble Cause possible Solution suggérée 1. Le ventilateur ne fonctionne pas lorsque l’interrupteur 1a. Un fusible peut être grillé ou un disjoncteur 1a. Remplacer le fusible ou réinitialiser le disjoncteur. est à...
  • Page 12 Réceptacle 2P Polarisé 5S1201012 Grille 5S1201016 Vis à métal #10 5S1201013 Lentilles 5S1201017 Clip du moteur ASLC 5S5201001 Support de la Lumière - ASLC50/ASLC70 5S1201018 Rondelle de Sécurité #10 5S1999007 Ballast - ASLC50FL 5S1201022 Écrou Borgne #10 5S1999008 Ballast - ASF50/ASF70 5S1201023...

Ce manuel est également adapté pour:

Aslc50flAsf50Aslc70Asf70