Les langues disponibles

Les langues disponibles

Liens rapides

IMPORTANT INSTRUCTIONS -
: AK863L, AK863FL
Models
READ AND SAVE THESE INSTRUCTIONS
READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT
YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH
INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE!
electric shock and injury to person, including the following:
1. Read all instructions before installing or using exhaust fan.
2. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer.
3. Before servicing or cleaning the unit, switch power off at
service panel and lock the service disconnecting means to
prevent power from being switched on accidentally. When
the service disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to the
service panel.
4. Installation work and electrical wiring must be done by
qualified person(s) in accordance with all applicable codes
and standards, including fire-related construction.
5. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent back drafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA)
and the American Society for Heating, Refrigeration, and Air
Conditioning Engineers (ASHRAE), and the local code authorities.
CAUTION:
FOR GENERAL VENTILATING USE ONLY. DO
NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS
AND VAPORS.
211572097 Rev. A 8-05
Downloaded from
www.Manualslib.com
OPERATING MANUAL
RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
GENERAL SAFETY INFORMATION
When using electrical appliances, basic precautions
should always be followed to reduce the risk of fire,
SAVE THESE INSTRUCTIONS
manuals search engine
6. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
7. Ducted fans must always be vented to the outdoors.
8. This unit must be grounded.
9. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off
power unit.
WARNING:
DO NOT USE THIS FAN WITH ANY SOLID-STATE SPEED CONTROL
DEVICE.
10. Acceptable for use over a bathtub or shower when installed
in a GFCI protected branch circuit.
11. NEVER place a switch where it can be reached from a tub or
shower.
WARNING:
www.airkinglimited.com
Exhaust Fan with Light
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
DO NOT USE IN KITCHENS
1 of 12
Table des Matières
loading

Sommaire des Matières pour AirKing AK863L

  • Page 1 IMPORTANT INSTRUCTIONS - OPERATING MANUAL : AK863L, AK863FL Exhaust Fan with Light Models READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED. PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION. FAILURE TO COMPLY WITH INSTRUCTIONS COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE! RETAIN INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2 INSTALLATION INSTRUCTIONS 5. Select the most convenient electrical knockout and remove CAUTION: MAKE SURE POWER IS SWITCHED OFF AT using a straight-blade screw driver SERVICE PANEL BEFORE STARTING INSTALLATION. (Figure 3). SECTION 1 Preparing the Exhaust Fan 1. Unpack fan from the carton and confirm that all pieces are SECTION 2 present.
  • Page 3 CAUTION: ALL ELECTRICAL CONNECTIONS MUST BE MADE IN ACCORDANCE WITH LOCAL CODES, ORDINANCES, OR NATIONAL ELECTRICAL CODE. IF YOU ARE UNFAMILIAR WITH METHODS OF INSTALLING ELECTRICAL WIRING, SECURE THE SERVICES OF A QUALIFIED ELECTRICIAN. 1. Run wiring from an approved wall switch carrying the appropriate rating.
  • Page 4: Flat Washer

    Sylvania model: CF26DD/841 4. Install the appropriate bulbs (not included) specific to your model: GE model: F26DBXT4/SPX41 AK863L: Install a 100 watt maximum, type A19 medium base Phillips model: PL-C 26W/41/ALTO incandescent bulb (not included) and a 7 watt maximum Refer to instructions in Section 6 Finishing the Installation , type C7 (candelabra base) night light (not included).
  • Page 5: Troubleshooting Guide

    Troubleshooting Guide Trouble Probable Cause Suggested Remedy 1. Fan does not operate when the switch is on. 1a. A fuse may be blown or a circuit tripped. 1a. Replace fuse or reset circuit breaker. 1b. Connector plug from motor is not plugged in. 1b.
  • Page 6: Replacement Parts Diagram

    Motor Bracket 5S3202008 Lock Washer 5S3202009 Motor Nut 5S3202020 5S3202021 Washer 5S3202022 Rubber Washer 5S3202023 Reflector Nut 5S3202024 Lamp Holder Assembly - AK863L 5S3202025 Screw 5S3202026 Reflector 5S3202027 Lens Screw 5S3202028 Lens Washer 5S3202029 Clip - Springs 5S3202030 Glass Lens...
  • Page 7: Instructions Importantes - Manuel D'opération

    INSTRUCTIONS IMPORTANTES – MANUEL D’OPÉRATION Ventilateur combiner, comprend : AK863L, AK863FL Modèles lumière et ventilation LIRE ET CONSERVER CES INSTRUCTIONS LIRE SOIGNEUSEMENT AVANT DE TENTER D’ASSEMBLER, INSTALLER, OPÉRER OU DE RÉPARER LE PRODUIT DÉCRIT. PROTÉGEZ VOUS-MÊME ET LES AUTRES EN OBSERVANT TOUTE L’INFORMATION DE SÉCURITÉ. FAILLIR À SE CONFORMER AUX INSTRUCTIONS PEUT RÉSULTER EN BLESSURE PERSONNELLE GRAVE ET/OU EN DOMMAGE À...
  • Page 8: Réflecteur

    INSTRUCTIONS D’INSTALLATION sur la solive à l’aide des onglets de montage où entre les 40,6cm (16po) AVERTISSEMENT: VOUS ASSURER QUE L’ALIMENTATION au centre des solives en utilisant les EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER 4 traverses de montages fournies. L’INSTALLATION.
  • Page 9 SECTION 5 Câblage AVERTISSEMENT: VOUS ASSURER QUE L’ALIMENTATION EST COUPÉE AU PANNEAU DE SERVICE AVANT DE COMMENCER L’INSTALLATION. AVERTISSEMENT: TOUTES LES CONNEXIONS DOIVENT ÊTRE FAITES EN CONFORMITÉ AVEC LES CODES ÉLECTRIQUES LOCAUX OU NATIONAUX. SI VOUS N’ÊTES PAS FAMILIER AVEC LES MÉTHODES D’INSTALLATION DE CÂBLAGE ÉLECTRIQUE, Figure 6 RECOURREZ AUX SERVICES D’UN ÉLECTRICIEN QUALIFIÉ.
  • Page 10 (Figure 14). spécifiques à votre modèle: Ampoule Incandescente (AK863L): Dévisser l’ampoule du AK863L: Installer une ampoule incandescente à culot socle et la remplacer avec une ampoule incandescente moyen de type A19 (non-comprise) et une ampoule d’un d’un maximum de 100 watts, de type A19 à...
  • Page 11: Cause Possible

    Lumière de Nuit (AK863L, AK863FL): Dévisser l’ampoule de lumière de nuit de son socle et la remplacer avec une ampoule de lumière de nuit de type C7 d’un maximum de 7 watts (culot de type candélabre). Référez-vous à la Section 6 Terminer l’installation , pour réinstaller la grille.
  • Page 12: Diagramme Des Pièces De Remplacement

    5S3202009 Écrou du moteur 5S3202020 Écrou 5S3202021 Rondelle 5S3202022 Rondelle de caoutchouc 5S3202023 Écrou du réflecteur 5S3202024 Assemblage du socle de lampe - AK863L 5S3202025 5S3202026 Réflecteur 5S3202027 Vis de lentilles 5S3202028 Rondelles de lentilles 5S3202029 Clip – ressorts 5S3202030...

Table des Matières