Blade Replacement - Cembre B-TC250 Notice D'utilisation Et Entretien

4. BLADE REPLACEMENT

When changing blades, the battery must fi rst be removed from the tool.
After extended use, the blades may break or loose their cutting edge.
Replace the blades as follows:
Lower blade
– Release latch (2), and open the tool head completely.
– Operate the tool to advance the lower blade (4) and remove the battery.
– Eject two split pins (12) from the ram (13) to release the blade (4).
– Remove the broken blade to the ram, insert the new blade and fi t with two split pins.
Before closing the tool head, push the release button (6) and fully retract the lower blade,
otherwise the tool head assembly may hit and damage, the lower blade.
Upper blade
– Release latch (2), and fully open the tool head.
– Remove circlip (16) and extract the head pin (15) to release the latch.
– Remove circlip (23) and latch pin (15) to release the latch.
– Remove the latch and recover the latch spring (24).
– Using a 10 mm spanner, remove 8 nuts (22) and relevant washers (21).
– Remove 4 studs (18), releasing the broken blade (20).
– Position the new blade, insert 4 studs (18), fi t 8 washers (21) and light tighten 8 nuts (22).
– Insert the latch spring (24) into the spacer (19).
– Reassemble the latch (2) and fully tighten the 8 nuts (22).
– Fit the head assembly to the head support using the pin (14) and circlip (16).
5. RETURN TO Cembre FOR OVERHAUL
In the case of a breakdown, contact your local Agent who will advise you on the problem and give
you the necessary instructions on how to dispatch the tool to our nearest service Centre; if possible,
attach a copy of the Cembre Test Certifi cate supplied with the tool or, if no other references are
available, indicate the approximate purchase date and the tool serial number.
Following information applies in member states of the European Union:
USER INFORMATION in accordance with "Directives 2002/95/EC and 2002/96/EC.
The 'Not in the bin' symbol above when shown on equipment or packaging means that the
equipment must, at the end of its life, be disposed of separately from other waste.
The separate waste collection of such equipment is organised and managed by the manufacturer.
Users wishing to dispose of such equipment must contact the manufacturer and follow the prescri-
bed guidelines for its separate collection. Appropriate waste separation, collection, environmentally
compatible treatment and disposal is intended to reduce harmful environmental eff ects and pro-
mote the reuse and recycling of materials contained in the equipment. Unlawful disposal of such
equipment will be subject to the application of administrative sanctions provided by current legi-
slation.
9
(Ref. to Fig. 5)