Endress+Hauser Proservo NMS81 Manuel De Mise En Service page 297

Proservo NMS81
Entrée
Réglage usine
Information
supplémentaire
Density value
Navigation
Description
Information
supplémentaire
Minimum level
Navigation
Description
Entrée
Réglage usine
Information
supplémentaire
Pression minimale
Navigation
Description
Entrée
Endress+Hauser
0 ... 3 000 kg/m³
800 kg/m³
Accès en lecture
Accès en écriture
 Configuration → Config. étendue → Application → Tank calculation → HTMS
→ Density value
Shows the calculated product density.
Accès en lecture
Accès en écriture
 Configuration → Config. étendue → Application → Tank calculation → HTMS → Min.
level
Defines the minimum product level for a HTMS calculation.
If Lp - V falls below the limit defined in this parameter, the density retains its last value or
the manual value is used instead.
0 ... 20 000 mm
7 000 mm
Accès en lecture
Accès en écriture
 Configuration → Config. étendue → Application → Tank calculation → HTMS
→ Pression minim.
Defines the minimum pressure for a HTMS calculation.
If the pressure P1 (or the difference P1 - P3) falls below the limit defined in this
parameter, the density retains its last value or the manual value is used instead.
0 ... 100 bar
Maintenance
Maintenance
Opérateur
-
Opérateur
Maintenance
Menu de configuration


297