Publicité
Les langues disponibles
Les langues disponibles
System Connections (continued)
! Placing the speaker system
The left and right speakers have individual shapes. For best performance, place the
speakers according to the diagram below.
Left speaker
Notes:
" The speakers are magnetically shielded.
Therefore, they do not affect the display even you use them near the TV. However,
some colour variation may occur, depending on the type of TV used.
If colour variation occurs...
Turn off the TV (from the power switch).
After 15 - 30 minutes, turn the TV on again.
If the colour variation is still present...
Move the speakers further away from the TV.
" If any kind of magnet or an electromagnet is placed too close to the TV and the sys-
tem, irregular colours may appear on the TV screen.
Speaker grilles are removable:
Make sure nothing comes into contact with the speaker
diaphragms when you remove the speaker grilles.
ENGLISH
E-9
All manuals and user guides at all-guidesbox.com
Bi-amp system:
Each speaker unit has a built-in subwoofer (low frequency range) which is driven sep-
arately from the woofer and tweeter (mid-to-high frequency range). Two independent
amplifiers which have individual frequency characteristics are used. By amplifying
separately the two frequency bands, clearer sound is achieved.
Right speaker
! TV/monitor connection
If the TV/monitor has a video input, connect it to VIDEO OUT socket on the rear of
the unit.
Note:
If the TV/monitor does not have a video input, the VIDEO OUT socket on the unit
should be connected to a VCR with a video input, which in turn should be connected
to the TV/monitor through the TV ANTENNA/CABLE input. (Be sure to turn on the
VCR, and set the VCR's input mode to "Auxiliary".)
Power amplifier
Tweeter
Sub-
woofer
Woofer
Power amplifier
01/4/24
CD-BK310V(X)E1.fm
Mid-to-high range
(200 Hz - 20 kHz)
Pre-amplifier
L-ch
Pre-amplifier
Ultra-low range
(60 Hz - 200 Hz)
TV
To video
input socket
Video cable
Publicité
