Publicité
Les langues disponibles
Les langues disponibles
Oil Recommendations
We recommend use of Kohler oils for best
performance. Other high-quality detergent
oils (including synthetic) of API (American
Petroleum Institute) service class SJ or higher
are acceptable. Select viscosity based on air
temperature at time of operation as shown in
table below.
5W-30
°F -20
0
20
32
40
°C -30
-20
-10
0
Check Oil Level
NOTE: To prevent extensive engine wear or
damage, never run engine with oil level
below or above operating range
indicator on dipstick (I).
Ensure engine is cool. Clean oil fill plug/dipstick
(I) areas of any debris.
1. Remove oil fill plug/dipstick (I); wipe oil off.
2. Remove oil fill plug/dipstick (I); check oil
level. Level should be at top of indicator on
dipstick (I).
3. If oil is low, add oil up to point of overflowing
filler neck.
4. Reinstall oil fill plug/dipstick (I) and tighten
securely.
Change Oil
Change oil while engine is warm.
1. Clean area around oil fill plug/dipstick (I) and
oil drain plug (H).
2. Remove oil drain plug (H) and oil fill plug/
dipstick (I). Drain oil completely.
3. Reinstall oil drain plug (H). Torque to 13 ft. lb.
(17.6 N·m).
4. Fill crankcase with new oil, up to point of
overflowing filler neck.
5. Reinstall oil fill plug/dipstick (I) and tighten
securely.
6. Dispose of used oil in accordance with local
ordinances.
37 590 02 Rev. F
All manuals and user guides at all-guides.com
10W-30
SAE 30
50
60
80
100
10
20
30
40
KohlerPower.com
Oil Sentry
(if equipped)
™
This switch is designed to prevent engine
from starting in a low oil or no oil condition. Oil
Sentry
may not shut down a running engine
™
before damage occurs.
Fuel Recommendations
Explosive Fuel can cause fires
and severe burns.
Do not fill fuel tank while engine is
hot or running.
Gasoline is extremely flammable and its
vapors can explode if ignited. Never refuel
while smoking or in vicinity of an open flame.
Store gasoline only in approved containers,
in well ventilated, unoccupied buildings, away
from sparks or flames. Spilled fuel could
ignite if it comes in contact with hot parts or
sparks from ignition. Never use gasoline as a
cleaning agent.
NOTE: E15, E20 and E85 are NOT approved
and should NOT be used; effects of
old, stale or contaminated fuel are not
warrantable.
Fuel must meet these requirements:
● Clean, fresh, unleaded gasoline.
● Octane rating of 86(R+M)/2 or higher.
● Research Octane Number (RON) 91 octane
minimum.
● Gasoline up to 10% ethyl alcohol, 90%
unleaded is acceptable.
● Methyl Tertiary Butyl Ether (MTBE) and
unleaded gasoline blend (max 15% MTBE by
volume) are approved.
● Do not add oil to gasoline.
● Do not overfill fuel tank.
● Do not use gasoline older than 30 days.
EN
WARNING
7
Publicité
