Kohler K-1360-H2 Guide De Propriétaire page 4

Activates Mode Selected
Waterfall Mode
Rotate outer ring to
access desired mode.
Power On/Off
Chromatherapy-Specific Color
(H2 models only)
User Keypad
Available modes will be illuminated in blue. Active modes will be illuminated in green.
Power Turns the whirlpool pump on and off.
Outer Ring Rotate the outer ring to the desired mode. The selected mode will flash blue.
Waterfall Mode Rotate the outer ring to select this mode, then press OK. Press the up or down arrow icons
to increase or decrease the water flow. The indicator bar will display the water flow volume.
This mode may be used alone or with the Flexjet Flow, Riverjet Whitewater, or Riverjet
Rapids mode.
OK Activates the desired mode.
Flexjet Flow Rotate the outer ring to select this mode, then press OK. Press the up or down arrow icons
Mode to increase or decrease the water flow. The indicator bar will display the water flow volume.
Riverjet Rotate the outer ring to select this mode, then press OK. Press the up or down arrow icons
Whitewater to increase or decrease the water flow. The indicator bar will display the water flow volume.
Mode
Up Arrow Increases the water flow.
Riverjet Rapids Rotate the outer ring to select this mode, then press OK. Press the up or down arrow icons
Mode to increase or decrease the water flow. The indicator bar will display the water flow volume.
Indicator Bar Displays the water flow volume.
Tidepool Rotate the outer ring to select this mode, then press OK. Press the up or down arrow icons
to increase or decrease the water flow. The indicator bar will display the water flow volume.
This mode may be used at any time while any of the jets are operating. This mode does not
affect the Waterfall mode. Some air may flow from one or more jets for a short time after
this mode has been activated.
Down Arrow Decreases the water flow.
Chromatherapy H2 models: Rotate the outer ring to select this mode, then press OK. The chromatherapy
Cycle lights will automatically and continuously cycle through eight colors. One cycle through all
eight colors takes approximately one minute. Only one of the two keypads controls this
mode.
Heater Automatically engages when the power icon is selected. Rotate the outer ring until the
heater mode is flashing, then press OK to turn the heater off. Press OK again to turn the
heater back on.
Chromatherapy H2 models: Rotate the outer ring to select this mode, then press OK. Press the up or down
Specific Color arrow to select a color, then press OK again. Only one of the two keypads controls this
mode.
Sleep Mode
Approximately 15 seconds after user keypad inactivity, only the last mode selected on the user
keypad will illuminate. Press any mode or turn the outer ring to illuminate the entire user keypad.
Approximately 60 seconds after the whirlpool is powered off, the keypad will darken completely to
conserve power. Press the power button or turn the outer ring to reactivate the user keypad.
1022211-5-F
All manuals and user guides at all-guides.com
Flexjet Flow Mode
Lighted User Keypad
Riverjet Whitewater Mode
Increases Flow
Riverjet Rapids Mode
Indicator Bar - Shows
water flow volume
Tidepool
Decreases Flow
Chromatherapy Cycle
(H2 models only)
Heater
4 Kohler Co.