Wolf Garten Esprit 40 E Mode D'emploi page 13

Assembly
Fixing of handle A B C
ATTENTION! Take care that theswitch cable does not
become caught and crused when folding the handle frame.
Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Inserting power cable into cable holder F
Insert the power cord into the strain relief as shown in the
illustration.
Hanging the grass bag G
Only when the motor is not running and the
cutting blade is not moving.
1. Lift the protective fl ap.
2. Hang the grass bag in the chassis with the hooks in the
recesses (see arrow).
3. Replace the protective fl ap.
Adjustment of cutting height H
Only when mower is stationary and rotating blade
has come to complete standstill.
1. Press button (1).
2. push chassis downwards or pull upwards, as required.
3. Release button at required cutting height (2).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do not
se cutting position too low when mowing very hight or wet grass.
We recommend an average cutting height of 4,0 - 5,0 cm.
Connecting to the mains
(230 Volts, A.C., 50 Hz)
The mower operates from any normal household mains
supply, provided with a 16 Amps. fuse.
Note: Use a residual current device (RCD) rated for a
residual current not greater than 30 mA.
Maintenance
Cleaning
Note: Disconnect electricity by unplugging cable
at the socket before proceeding. Attention: Keep
hands clear of moving blade.
Clean mower thoroughly after each mowing with cloth or
brush.
Do not spray with water.
Winter Storage
• Clean mower thoroughly before storing away.
• Have your mower thoroughly checked once a year by an
approved Service Centre.
• Do not store it in a wet or humid place.
All manuals and user guides at all-guides.com
Mount grass catcher D E
Starting and Stoping J K
Emptying of Grassbox L
Tips for mowing
Change of cutter blade O
Adjusting the Bowden cable coupling P
See illustrations.
• Switch on motor with mowerplaced on level and firm ground
• not in high grass - alternatively tilt slightly
K
Switch-on motor
1. Depress button and hold (1).
2. Lift up bar (2).
3. release button (1).
Wheel drive on (only Esprit 46 EA)
Raise drive bracket (3).
Wheel drive off (only Esprit 46 EA)
Release drive bracket (3).
K
Switch-off motor
Release bar (2).
• the flap drops down when grassbox is full
• To ensure properfunctioning of the indicator it is important
that the grilles beloware kept clean using a hand brush.
Attention! Disconnect electricity by unplugging
cable at the socket-before proceeding.
M N
• Always let cable trail on the cut side of the lawn
• Cable guidance: Place the cable firmly off the lawn or on
the already cur side of the lawn when starting to mow.
• To prevent strips of grass from being left unmowed, the
cutting paths must always overlap a few centimeters
Always disconnect mains supply and wear
protective gloves before undertaking any work at
the cutter blades, cutter bar and blade coupling.
• Change of blades only be carried out by an approved service
station.
• Damaged blades should always be replaced in pairs to
ensure even balance.
Information for Service Centre, blade retaining screw to
be tightened to: A/F 13 mm = 16-18 Nm
1. Raise the drive bracket (1) app. 2 cm and hold.
2. Loosen the locking nut (2).
3. Turn the setscrew (3) left until the drive wheels are blocked
when you pull the mower backwards.
4. Tighten locking nut (2).
J
.
K
K
M .
N .
13