Publicité
Les langues disponibles
Les langues disponibles
The warning is not cancelled if the
power is cut when the hood gives
aluminium filter fill warning. When
the power is available, it continues
to warn with the light of
flashing.
If you run your hood at any speed
level with the aluminium filter fill
warning, the warning will not ap-
pear for as long as the hood is run-
ning. When you turn off the hood,
the fill warning starts flashing
again.
If you turn off the warning without
cleaning the aluminium filter, the
operating time of 100 hours is re-
set and it starts over. At the end of
the next 100 hours, your hood
warns again.
Carbon filter fill warning (for products with
carbon filter)
The light of
key flashes after every 100
hours of operation. In this case, you must
replace your carbon filter. Consult an au-
thorized service for this. After replacement,
the lamp warning of
off automatically. When you touch the
key for more than 3 seconds, carbon filter
fill warning is reset and the lamp is turned
off.
The warning is not cancelled if the
power is cut when the hood gives
carbon filter fill warning. When the
power is available, it continues to
warn with the light of
ing.
If you run your hood at any speed
level with the carbon filter fill warn-
ing, the warning will not appear for
as long as the hood is running.
When you turn off the hood, the fill
warning starts flashing again.
key
key does not turn
key flash-
If you turn off the warning without
replacing the carbon filter, the op-
erating time of 100 hours is reset
and it starts over. At the end of the
next 100 hours, warning is given
again.
Using the HomeWhiz application
Follow the steps described below to con-
trol and monitor your hood via a smart
device. You shall connect your tablet to
your home network, and download the
HomeWhiz application to your smart
device from the app store of your smart
device.
1. Open the application downloaded via
your smart device.
2. Press "add/remove product" section on
the smart device.
3. Perform the installation by following the
instructions provided on the smart
device.
4. Keep the function key pressed for about
5 seconds. The " " symbol shall flash
on the display.
5. Connect to your hood with the user
name and password given on the app
from the settings section of your smart
device.
6. Select the network you are using from
the network list and connect your hood
to the network with the required pass-
word. The " " symbol shall be dis-
played continuously when the installa-
tion is complete. You may enter your
app and start to use your hood by nam-
ing it from the "add/remove product"
section.
If it is not possible to establish a
network connection within 5
minutes after pressing the function
key for about 5 seconds, the in-
stallation of homewhiz application
shall be ended and the " " symbol
shall be turned off.
EN / 16
Publicité
