Publicité
Les langues disponibles
Les langues disponibles
If you want to have the filter change
time calculated automatically and
receive a warning at the end of usage
time, please read "Calculating the Filter
Usage Time Automatically" section.
The water filter must be removed as
shown in the figure when it is going to
be replaced or when it will no longer
be used and by-pass cover must be
attached. It must be made sure that
Ice Off mode is active before taking it
out.
C
Approximately the first 30 cubes
of ice to be obtained from the Ice
Dispenser must not be used.
C
Always use the water filter when a
jug is not being used.
All manuals and user guides at all-guides.com
A
foreign particles in the water. It does
not purify water from microorganisms.
A
be pressed during replacement of the
water filter or installing the by-pass
cover.
Prior to first use of Water
Dispenser
C
below 1 bar.
C
above 8 bars.
C
supply water pressure drops below 1
bar or if a jug is going to be used.
C
must be connected to the cold water
line. It must not be connected to hot
water line.
C
initial operation of the refrigerator. This
is caused by the air in the system. To
discharge air from the system, press
Dispenser latch for periods of 1 minute
until water comes from the Dispenser.
Water flow may be irregular in the
beginning. Irregular water flow will be
normalized after the air in the system is
discharged.
C
refrigerator approx.12 hours must pass
before cold water can be obtained.
C
between 1-8 bars for the operation
of Ice/Water Dispenser smoothly. For
this, check that 1 glass of water (100
cc) can be filled in 10 seconds.
C
not be consumed.
17
EN
Caution: Water filter cleans some
Caution: Ice Off button must always
Water mains pressure must not be
Water mains pressure must not be
Pumps must be used in case the
Water system of the refrigerator
No water may be obtained in the
At the initial startup of the
Water mains pressure must be
The first 10 glasses of water should
Publicité
