Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
the bubble is centered between the lines, the drill is in
the vertical level. For vertical drilling, align the drill so
that the bubble floats in the center of the bull's-eye. For
greater accuracy, place a level on your work-piece and
position it so that it is in the vertical level. Then, when
the drill reads level, the two will be aligned. (Any bubble
level can only indicate level to the earth's surface).
NOTE: The level is filled with mineral oil that may cause
minor skin irritation when contacted. If the level breaks
and this fluid gets on your skin, rinse thoroughly with
water. If any liquid gets in your eyes, rinse thoroughly
with water and call a physician immediately.
WORKING HINTS FOR YOUR
DRILL
If your power tool becomes too hot, set the speed to
maximum and run no load for 2-3 minutes to cool the
motor.
When drilling in metal, only use HSS,Titanium or Cobalt
drill bits that are in good condition.
Always use a magnetic bit holder when using short
screwdriver bits.
Where possible use a pilot hole before drilling a large
diameter hole in metal material.
09
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for better and safer perfor-
mance. Follow instructions for lubricating and changing
accessories. Inspect tool cords periodically and if dam-
aged, have repaired by authorized service facility.
Your power tool requires no additional lubrication or
maintenance. There are no user serviceable parts in
your power tool. Never use water or chemical cleaners
to clean your power tool. Wipe clean with a dry cloth.
Always store your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working controls
free of dust. If you see some sparks flashing in the ven-
tilation slots, this is normal and will not damage your
power tool.
WARRANTY
LIMITED 60-DAY EXCHANGE POLICY
During the first 60 days after date of purchase, you may
exchange a tool which does not work properly due to
defects in materials or workmanship by returning the
" /10mm Drill
3
/
WT100K
8
NA-WT100K C20-M-050727.indd 9
2005-7-27 17:48:12
Publicité
