Worx WT100K Mode D'emploi page 4

ADDITIONAL SAFETY RULES - FOR DRILLS
WARNING! Failure to follow these rules may result in serious personal injury.
1) Hold tool by insulated gripping surfaces when performing an operation where the
cutting tools may contact hidden wiring or its own cord. Contact with a "live" wire will
make exposed metal parts of the tool "live" and shock the operator.
2) Always wear ear protectors with impact drill. Exposure to noise can cause hearing
loss.
3) Always wear eye protectors when using tool. Use a dust mask or respirator for applica-
tions which generate dust.
4) Always use the auxiliary handle supplied with the tool. Keep a firm grip on the tool at
all times. Do not attempt to operate this tool without holding it with both hands.
5) Always check walls and ceiling to avoid hidden power cables and pipes.
6) Do not start the drill with the chuck key in the chuck.
7) Make sure the power switch is not "ON" before you plug the tool in. Accidental start-
ups could cause injury.
8) Make sure drill bits are tightened securely in the chuck.
9) Do not use damaged or worn drill bits. Dull or damaged bits have a greater tendency to
bind in the work-piece.
10)Use clamps or a vise to hold work-piece whenever possible.
11)Secure material before cutting. Never hold it in your hand or across your legs.
12)Save these instructions. Refer to them frequently and use them to instruct others who may
use this tool. If someone borrows this tool, make sure they have these instructions.
WARNING! Some dust created by power sanding, sawing, grinding, drilling and
other construction activities contains chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
04
• Lead from lead-based paint
• Crystalline silica from bricks and cement and other masonry products
• Arsenic and chromium from chemically-treated lumber
Your risk to these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals:
• Work in a well ventilated area
• Work with approved safety equipment, such as those dust masks that are specifically designed
to filter out microscopic particles.
The label on your tool may include the following symbols:
V...................................................................................................................................................................Volts
A..................................................................................................................................................................Amps
Hz.................................................................................................................................................................Hertz
~..........................................................................................................................................Alternating current
n ...............................................................................................................................................No-load speed
o
......................................................................................................................................Class II Construction
" /10mm Drill
3 /
8
NA-WT100K C20-M-050727.indd 4
All manuals and user guides at all-guides.com
WT100K
2005-7-27 17:48:07