Fein CCG18-115-10PD-SEC AS Mode D'emploi page 33

ings, metal, some wood types, minerals, silicate parti-
cles from materials containing stone, paint solvents,
wood preservatives, antifouling paints for vessels, can
trigger allergic reactions to the operator or bystanders
and/or lead to respiratory infections, cancer, birth
defects or other reproductive harm. The risk from
inhaling dusts depends on the exposition. Use dust
extraction matched appropriately for the developing
dust, as well as personal protective equipment and pro-
vide for good ventilation of the workplace. Leave the
processing of asbestos-containing materials to special-
ists.
Wood and light-metal dust, hot mixtures of grinding
dust and chemical materials can self-ignite under unfa-
vourable conditions or cause an explosion. Avoid
sparking in the direction of the dust collector as well as
overheating of the power tool and the materials being
sanded, empty the dust collector/container in time,
observe the material manufacturer's working instruc-
tions, as well as the relevant regulations in your country
for the materials being worked.
Operating Instructions.
Press the locking button only when the motor is
stopped (see page 6). Otherwise the power tool
may be damaged.
Adjusting the handle (see page 6)
– Open both engaging hooks.
– Remove the safety cover.
– Turn the clamping screw anticlockwise to the stop.
The clamping screw must be completely released.
Otherwise the power tool may be damaged.
– Adjust the handle to one of the handle positions.
– Tighten the clamping screw in clockwise direction.
Mounting the safety cover (see page 9)
– Slide the safety cover over the wheel guard.
– Pay attention that the two engaging hooks are fully
engaged.
Additional operating instructions.
The self-start prevention lock prevents the power tool
from automatically starting when the battery is inserted
while the on/off switch is set to on.
If the power tool shuts off without the switch being
actuated, switch the power tool switch off, remove the
battery and reattach it.
Switching on
To switch the angle grinder on, actuate the switch on
the motor housing (see page 9). The lamp lights up for
approx. 3 seconds. Within this time, actuate the switch
on the auxiliary handle. When the lamp goes out, the
angle grinder can no longer be switched on via the
switch on the auxiliary handle.
Features
The soft start is used to reduce torque reaction forces
when switching on and running up the power tool to
the no-load speed.
The restarting protection prevents the power tool from
automatically restarting if the power supply is inter-
rupted during operation. In this case, switch off the
power tool, check the power supply and then switch
the power tool on again.
The blocking monitor reduces the risk of motor damage
and the risk of accidents when an application tool
blocks. In this case, the power tool switches off auto-
matically. Afterwards, set the switch to the off position,
remove the power tool from the workpiece and check
the application tool for damage. Afterwards, switch the
power tool on again.
The electronic overload protection reduces the risk of
motor damage if the power tool is overloaded. In this
case, the power tool switches off automatically. After-
wards, set the switch to the off position, remove the
power tool from the workpiece and check the applica-
tion tool for damage. Afterwards, switch the power
tool on again.
The electronic speed preselection enables the speed to
be adapted to the respective application and the respec-
tive application tool.
The dead man's switch is a non-lockable switch. The
dead man's switch must be continuously actuated to
keep the power tool in operation.
The power tool is equipped with a brake system for
braking down the application tool. This reduces the risk
of accidents.
The kickback monitoring reduces the risk of unex-
pected kickback of the power tool. In this case, the
power tool switches off automatically. Afterwards, set
the switch to the off position, remove the power tool
from the workpiece and check the application tool for
damage. Afterwards, switch the power tool on again.
en
33