Publicité
Les langues disponibles
Les langues disponibles
B1
COnnECTiOnS AnD COnTrOlS AXTOn A2100X
q
HigH inPUT
High-level input port to connect the high-level adapter
plug to the speaker outputs of headunit, if no RCA line
out is available.
w
inPUT l+r
Low-level RCA input for connection to head-unit pre-out.
e
gAin
Input gain/sensitivity control allowing the matching of the
amplifier input section to the head-unit (pre-out) output
voltage.
r
HPF/lPF mODE SWiTCH
Depending on the selected switch setting the amplifier
operates in Highpass, Lowpass or Fullrange mode.
t
HPF/lPF FilTEr
Crossover filter frequency control allowing the setting of
the Highpass or Lowpass cut-off frequency between 50
and 250 Hz.
note: This control is not active when the amplification
mode switch is in 'Fullrange' position!
y
grOUnD/gnD
Power connection terminal to chassis ground or negative
terminal of car battery.
18
All manuals and user guides at all-guides.com
u
rEmOTE/rEm
Remote switching contact for the automatic (remote)
toggle-on/off of the power amplifier from the head-unit's
remote lead.
⑧
+12 V
Power connection terminal to the positive terminal of
the car battery.
⑨
FUSES
Fuses for protection of the amplifier-internal electronics
against overload or faulty operation.
a
s
/
POWEr lED/PrOTECT lED
Lit green when power is on. Lit red when amplifier is in
protect mode due to shorted speakers, overtemp. etc.
••
+ Speaker -
Speaker output terminals for one stereo speaker pair or
one single speaker connected in bridged mode (e.g. sub-
woofer). in bridged mode the minimum speaker
impedance is 4 ohms!
Publicité
