Publicité
PATCHING
Inflate the product, spray with soapy water
and look for bubbles (leaks).
Apply underneath patch, and make sure
there are no bubbles.
Sand the area that you are going to glue
and the patch. Do not sand the tear aid.
Apply the glue evenly on the patch, and
the patching area. Use a heat gun on the
patch or let it dry for 2 minutes.
For more information visit our Youtube Channel
Measure the tear aid type B, make sure
there is 1inch of space in all directions.
Measure PVC patch. Cut the patch, and
round out the corners.
Prepare the patch with MEK. Do not apply
MEK on the tear aid. Let it dry.
Apply the patch and add continuous
pressure to avoid bubbles. Let it cure for
24 hours.
23
Publicité
