Husqvarna L 221P Manuel D'utilisation page 17

2. Put the mulch plug into the collector channel.
3. Close the rear deflector and make sure that it is
tightly closed against the mulch plug.
To change the product to side
discharge mode
1. Lift the rear deflector and remove the grass bag, if it
is installed.
2. Close the rear deflector and make sure that it is
tightly closed against the product.
1219 - 002 - 08.07.2019
3. Open the side discharge guard and install the side
discharge deflector.
4. Let the side discharge guard close against the side
discharge deflector. Make sure that the side
discharge deflector is tightly in position before you
operate the product.
To empty the grass catcher
CAUTION: Do not drag the bag when you
empty the grass catcher to prevent wear.
1. Lift the grass catcher with the frame handle.
2. Remove grass clippings from the grass catcher from
below the handle.
3. Empty grass clippings from the bag with the frame
handle and the bag handle.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Cut first with the cutting height set high. Examine the
result and lower the cutting height to an applicable
level. If the grass is very long, drive slowly and cut 2
times if necessary.
11