Eaton Ellipse PRO 650 Manuel D'installation Et D'utilisateur page 9

5. UPS setting through the LCD
Release scroll down button to select menu
5s
Output voltage
Example of setting
LCD shut off if no activity for 3 minutes.
l
6. Operation
Battery charge
The UPS charges the battery as soon as it is connected to the AC outlet, whether button
6 is pressed or not. When used for the first time, the battery will only provide its
maximum performance after it has been charged for 8 hours. It is recommended that
the UPS be permanently connected to the AC power supply to ensure the best possible
performance.
Switching-on the UPS
Press button 6 for about 1 second.
Surge protection outlets 18 without battery backup
Equipment connected to these outlets is supplied as soon as the AC cord 4 is plugged
in. They are not affected by button 6 .
Battery backup outlets 19
Equipment connected to these outlets is supplied as soon as button 6 turns green
(see figure D).
These outlets can be turned on even if the UPS is not connected to AC power
(button 6 flashes).
8
2s 2s
Input voltage EcoControl
tolerance
(165 - 264 V)
(150 - 284 V)
10s 5s
Save the new value
2s 2s
Alarm
5s
614-06817-00