Radio; Storing And Receiving Stations; Storing Automatically - Btm; Storing Manually - Sony CDX-GT730UI Mode D'emploi

Radio

Storing and receiving stations

Caution
When tuning in stations while driving, use Best
Tuning Memory (BTM) to prevent an accident.
Storing automatically — BTM
1
Press (SOURCE) repeatedly until
"TUNER" appears.
To change the band, press (MODE)
repeatedly. You can select from FM1, FM2,
FM3, AM1, or AM2.
2
Press and hold the select button.
The setup display appears.
3
Rotate the control dial until "BTM"
appears, then press the select button.
The unit stores stations in order of frequency
on the number buttons.
A beep sounds when the setting is stored.

Storing manually

1
While receiving the station that you
want to store, press and hold a
number button ((1) to (6)) until
"MEM" appears.
Note
If you try to store another station on the same number
button, the previously stored station will be replaced.

Receiving the stored stations

1
Select the band, then press a number
button ((1) to (6)).
12

Tuning automatically

1
Select the band, then press (SEEK) +/–
to search for the station.
Scanning stops when the unit receives a
station. Repeat this procedure until the
desired station is received.
Tip
If you know the frequency of the station you want to
listen to, press and hold (SEEK) +/– to locate the
approximate frequency, then press (SEEK) +/–
repeatedly to fine adjust to the desired frequency
(manual tuning).
Receiving a station through a list
— LIST
You can list up the frequency.
1
Select the band, then press
The preset list appears.
2
Rotate the control dial until the
desired station appears.
3
Press the select button to receive the
station.
The display returns to normal reception
mode.
(LIST).